top of page


Public·6 members

Lava Iris 65 Flash File MT6739 Frp Dead Hang Logo Fix Firmware

Lava Iris 65 Flash File MT6739 Frp Dead Hang Logo Fix Firmware

Lava Iris 65 is a smartphone that runs on the Mediatek MT6739 processor and has a 5-inch display, 1 GB of RAM, and 8 GB of internal storage. It was released in 2018 and runs on Android 8.1 Oreo operating system. However, some users may face various problems with their device, such as:

  • Hang on logo or boot loop

  • Frp (Factory Reset Protection) lock

  • Dead boot or no power

  • Software update failure or error

  • IMEI invalid or null

  • Network or signal problem

  • Camera or sound problem

  • Other software issues

If you are one of those users who are facing any of these problems with your Lava Iris 65, then you may need to flash your device with the official stock firmware. Flashing is the process of installing a new software or operating system on your device. It can help you to fix any software-related issue and restore your device to its original state.


How to flash Lava Iris 65 with stock firmware?

To flash your Lava Iris 65 with the stock firmware, you will need the following tools and files:

  • A computer running Windows OS

  • A USB cable to connect your device to the computer

  • The official stock firmware file for Lava Iris 65 in scatter format

  • The SP Flash Tool software

  • The MTK USB Driver for your device

  • A backup of your personal data and files (optional but recommended)

Once you have downloaded and installed all the required tools and files, you can follow these steps to flash your device:

  • Extract the firmware file and the SP Flash Tool software to a folder on your computer.

  • Open the SP Flash Tool folder and run the flash_tool.exe file as administrator.

  • Click on the Choose button under the Scatter-loading File section and browse to the folder where you extracted the firmware file. Select the MT6739_Android_scatter.txt file and click Open.

  • The SP Flash Tool will load all the partitions of the firmware file. Make sure that all the partitions are checked except for Preloader and Userdata.

  • Click on the Download button at the top of the SP Flash Tool.

  • Turn off your device and remove the battery if possible. Then connect your device to the computer using the USB cable.

  • The SP Flash Tool will detect your device and start flashing it. You will see a red bar followed by a yellow bar at the bottom of the tool.

  • Wait for the flashing process to complete. It may take a few minutes depending on the size of the firmware file.

  • When the flashing is done, you will see a green tick mark with a Download OK message at the top of the tool.

  • Disconnect your device from the computer and insert the battery if you removed it. Then turn on your device and wait for it to boot up.

Congratulations! You have successfully flashed your Lava Iris 65 with the stock firmware. You can now enjoy using your device without any software issues.

Tips and warnings

  • Before flashing your device, make sure that your battery is charged at least 50% to avoid any interruption or failure.

  • Do not disconnect or interrupt the flashing process until it is completed, otherwise you may brick your device.

  • Do not flash your device with a wrong or incompatible firmware file, otherwise you may damage your device.

  • Flashing your device will erase all your personal data and files, so make sure that you have a backup of them before proceeding.

  • Flashing your device may void your warranty, so proceed at your own risk.

If you have any questions or problems regarding flashing your Lava Iris 65, you can watch this video tutorial or visit this website for more information and support.

I hope this article was helpful for you. Thank you for reading!

  • About

    Welcome to the group! You can connect with other members, ge...

    Group Page: Groups_SingleGroup
    bottom of page